[Alan]

Originally Posted by dothemath

Ice Pick to push out the pins after removing cottar pins



Push back pads with towel and large pliers



Remove shims



Watch brake fluid level



Clean parts




Apply brake squeal reducer on back of pads and shims and insert after 10 minutes



Cottar pin



Place spring and insert second pin and cottar


Done



Move to the back...but now the pins come towards you





Use 130 or so grit to sand the rust from the hubs where the wheels make contact and clean the old brake material off of the rotors...per instructions on hawk hps sight. Now bed your pads per manufactures directions. Mine were approx 8 moderate force stops from 35 and 2-3 hard stops from 45, then let brakes cool.

asdf