[JOKER]

This is 07 sedan but our sh!t is similar (at least mine is.....05)

Originally Posted by 07G35Socal

So I took the plunge today and took the dremel to my shift lever. Shortened my lever by about 3/4 inch.







I had to increase the 2 solts down the front and back side of the shifter, then cut the outer lever to the desired length.



Once the outside was short I worked on the inside. You can pull the white top off the metal pole.





For the inner pole that controls the shifting I cut it down to length.




After the shaft was close I worked on the white piece. I cut the bottom clip off and then shortened the top section. Took a lot of fitting to get both the center pole and the white piece to the proper lengths for perfect function. Used some 2 part epoxy for plastics to reconnect the clip and the top of the white piece.





Still need to go get some lube for the shaft and the white tip.


Jason,
Don't bother cutting open a knob, they will not be able to be modified to sit lower. Heres a couple of pics of my knob (that doesn't sound right, LOL)




If you want to take a look inside one just stick a small flat head into the top side of the button, it pops right out.