|
|
|
|
|||||||
|
|
 |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
#1
08-26-2008, 06:02 PM
|
||||
|
||||
|
wiring a sub to a sub box
I'm a noob and don't know what to do. I've got my JL 10W3v2 and want to mount it to my subbox, but I can't figure out what wires to connect where. There is a positive and negative wire coming from the sub box, and a small wire to be connected from 1 end of the sub to another end. (this is how it was set up in my old box). now how do I plug it in? I've got 2 connections at the top of the sub and 2 at the bottom. Do I plug the positive on the top and negative on the bottom and then use the small cable to connect the remaining top to the remaining connection on the bottom?
__________________
 05 BS Coupe - Silver Sevas S-22 | Tein G35 S-Techs | Invidia G200 Exhaust | Stillen Sways | 35% Front & 20% Rear Tint | 06 Projectors | AEM Intake | JL 10W3v2
|
|
#2
08-27-2008, 12:23 AM
|
||||
|
||||
|
The way you wire the sub will depend on your amp and whether is can handle low imedances (lower om numers). It will also depend on the impedance rating of your dual voice coil sub.
More info about the amp and the sub are needed.
__________________
Sean Florida G Club '03.5 Caribbean Blue 5at Sedan w/ a few mods, '04 Laser Red 6mt Coupe slowly being demodded
|
|
#3
08-27-2008, 01:00 AM
|
||||
|
||||
|
yea i found the instructions that came w/ the sub and amp haha.. i had a shop install it the first time and i was like.. wait where do these plug in? i got it all worked out tho
__________________
05 BS Coupe - Silver Sevas S-22 | Tein G35 S-Techs | Invidia G200 Exhaust | Stillen Sways | 35% Front & 20% Rear Tint | 06 Projectors | AEM Intake | JL 10W3v2
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
