DIY: NRG Hood Props Installed
#1
DIY: NRG Hood Props Installed
I recently added a set of Polished NRG Hood Props on my '04 Coupe. I followed the directions given from Infiniti Help.com
http://www.infinitihelp.com/diy/gsed...stallation.htm
The installation didn't happen exactly like the video. When I shut the hood after the props were installed there was no problems, but when I raised the hood it chipped paint off my fenders. I ended up loosening all four bolts and re-aligning the hood so I wouldn't rub anymore. I still open the hood slowly and like having the access to the engine bay without the original hood prop.
http://www.infinitihelp.com/diy/gsed...stallation.htm
The installation didn't happen exactly like the video. When I shut the hood after the props were installed there was no problems, but when I raised the hood it chipped paint off my fenders. I ended up loosening all four bolts and re-aligning the hood so I wouldn't rub anymore. I still open the hood slowly and like having the access to the engine bay without the original hood prop.
#4
This post was just to inform people how things went when I installed this modification. As with all "mods" and aftermarket applications, things can happen different then normally should. The instructions were awesome! I think my hood was stressed from heat/wear, so when I loosened the two bolts it ended up relieving some tension and the hood shifted, causing it to rub my fenders.
Thread
Thread Starter
Forum
Replies
Last Post
R1 Autoworks
Exterior-Vendor
1
07-03-2019 07:16 PM
FS[SoEast]: 2006 DG Coupe Part Out - mrev2, projectors, etc
bu villain
Accessories
63
08-25-2016 07:14 PM