DIY: Spring Install Only
#155
Nice write up, however, compressing the new springs isn't needed. They're already shorter than the factory springs and you'll be able to put the spring and strut together without the use of a compressor. I know I did and I'm on a mild drop. Also, the only thing I needed to unbolt on the lower portion was the lower bolt to the strut. Unbolting control arms or endlinks isn't needed. Good write up though.
#156
17mm nut won't come off!
Good evening, I'm hoping some can help me out. I'm installing my eibach pro kit today, but the 17mm but won't come off. I took them off a month ago with ease. The bolt itself is lined up and will rotate. I've used plenty of PB blaster so I know it's not trusted. Now I'm at the point where the nut is starting to round out and it's going to rain soon. I'm thinking about cutting the bolt and replacing it. I also need to know where to buy a new bolt and nut. Any advice would be helpful.
Thanks
Thanks
#157
Good evening, I'm hoping some can help me out. I'm installing my eibach pro kit today, but the 17mm but won't come off. I took them off a month ago with ease. The bolt itself is lined up and will rotate. I've used plenty of PB blaster so I know it's not trusted. Now I'm at the point where the nut is starting to round out and it's going to rain soon. I'm thinking about cutting the bolt and replacing it. I also need to know where to buy a new bolt and nut. Any advice would be helpful.
Thanks
Thanks
#158
Thanks for the advice. That was my oh **** plan, but it looks like I'm going to have to. I just don't understand why it's happening. The rear passenger bolt came off with no problem, but now I can't tighten it. I went to the rear driver side and its doing the same thing. I can't even get it off and like I said I took these off with no issues a month ago.
#159
Top strut lock nut
So I forgot to completely tighten the main strut bolt up top b4 installing new struts and springs. So I've been trying to use an adjustable wrench to hold piston shaft and a 17mm ratchet but it seems like I'm getting nowhere. Any advice I'm in the mid west and I rented the spring compressor tool from AutoZone and it's too big to use to decompress spring far enough to bolt down. I did tein s techs, new kyb struts, new boots, and struts mounts.
#161
Thread
Thread Starter
Forum
Replies
Last Post
FS[Texas]: KSport Air Suspension G35/350Z/M35
privatecorye
Steering & Suspension
1
05-31-2016 01:56 AM
netcbc
Steering & Suspension CDN
0
07-24-2015 11:25 AM