DIY: JWT Pop-Charger and/or Z Tube install guide
#46
#54
Super Moderator
iTrader: (3)
To flip the tubes, unscrew two hose clamps, the one bolt connected to the plenum, and disconnect the clamp below the G-tube. Reconnect all for that to go in.
As for the JWT, you take the original intake out, flip the MAF housing, putting the four bolts into the pop charger.
Can't be any simpler then that.
As for the JWT, you take the original intake out, flip the MAF housing, putting the four bolts into the pop charger.
Can't be any simpler then that.
The following users liked this post:
Topspeed1013 (02-16-2014)
#56
I can’t see instructions!!
i have the following detailed installation guides on my blog myg35mods.com:
1. JWT Pop-Charger install
2. Z Tube install
3. JWT Pop-Charger with Z tube combo install
1. JWT Pop-Charger install
2. Z Tube install
3. JWT Pop-Charger with Z tube combo install
Thread
Thread Starter
Forum
Replies
Last Post