trunk wont open :? help please
#1
trunk wont open :? help please
my remote wont open it, neither will the switch on the dash. i have 6volts at the switch on the dash. and replaced the fuse - does anyone have any info that can help. also my passenger seat motor quit working the other day. and if one more thing messes up. im going to have to let her go
currently have a cable running to the emergency release between the seat and up the console so that i can at least utilize it somewhat.
currently have a cable running to the emergency release between the seat and up the console so that i can at least utilize it somewhat.
#3
#7
Trending Topics
#8
#9
i had to crawl through to open it a week or so ago. there is currently a long piece of picture hanging wire tied to the release, run between the seat back and seat cushion up my console so i can open it.
#10
This is a known problem with the G coupes. The wires that go to the trunk popper are a CM too short and are likely to snap at some point.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
#11
Hes right...After some searching, I found a DIY to fix this. Should have searched harder OP.
https://g35driver.com/forums/general...estions-3.html
https://g35driver.com/forums/general...estions-3.html
#12
This is a known problem with the G coupes. The wires that go to the trunk popper are a CM too short and are likely to snap at some point.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
#14
This is a known problem with the G coupes. The wires that go to the trunk popper are a CM too short and are likely to snap at some point.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
Hes right...After some searching, I found a DIY to fix this. Should have searched harder OP.
https://g35driver.com/forums/general...estions-3.html
https://g35driver.com/forums/general...estions-3.html
i will also try this prior to checking the wiring - and i’ll get back to you on that.
#15
This is a known problem with the G coupes. The wires that go to the trunk popper are a CM too short and are likely to snap at some point.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
Open your trunk, remove the liner, and remove the rubber wire housing where the wires runs out of the trunk lid.
This is usually where the snapped wires are. Solder and shrink wrap more wire onto those wires to extend them so it doesn't happen again.
alright so i gutted the whole trunk today. i also ran 12v straight to the trunk popper/actuator (what ever its called) - IT WORKS. so i start back tracking down the power supplying wires as far as i can (around the rear seat area) and cut the wire back to test periodically - NO POWER. so i double checked the fuse panel by the driver seat - its Good. soo now im kind of stuck - is there another fuse or relay somewhere that im overlooking?
im between a rock and a hard place right now.
check the wire for a break - and its good
i also tried the key in the ignition and trying it - still no go.