|
|
|
|
|||||||
|
|
 |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
#2
08-18-2008, 09:22 PM
|
||||
|
||||
|
It's just a snap seal. Stick a thin flat head screw driver in between the seam. You'll need to do it in several locations. Also, be careful cause the screw driver will mark the delicate plastic. I just put a dab of silicone sealant on anything that might rub. Also ran it all alone the seam and them wiped the excess when the two halves were rejoined.
|
|
#3
08-29-2008, 09:16 PM
|
|||
|
|||
|
My mirror rattle was because the screw that attaches the mirror to the windshield bracket was not tight. A few days after snuging the screw up nice the bracket came off the windshield. Once I glued the bracket back on and tightened up the screw not quite so tight it has been good.
|
|
#4
08-30-2008, 01:43 AM
|
|||
|
|||
|
I had a rattle problem and thought it was my mirror but it turned out it was my sunglasses rattling from the subwoofer haha.
__________________
My photography: www.infinusphoto.com My Car: 05 IP G35 coupe | HKS | Eibach | SPC | JWT | Z-tube | Motordyne | Grounding Gear | Tenzo-R type M V1 wheels | AAC | Valentine 1 | Carbign Craft
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
