View Full Version : Brakes & Suspension



  1. Alingment after DF210s???
  2. Group Buy on Hawk HPS Brake Pads
  3. Stance GR+, go with OEM or True coilover version?
  4. Verify my proposed suspension alignment please
  5. Front camber and toe on a sedan??
  6. Do I need to cut the rear for the SPC kit?
  7. Stance coilovers
  8. Unrevised 03/04 350z Springs
  9. What size wrench to unbolt front calipers on '06?
  10. what springs will give me a no gap drop all around on a coupe?
  11. air suspenion advice
  12. suspension set up
  13. sway bar installation
  14. Is there anyway to tune the suspention?
  15. need sum advice on brake upgrade
  16. just installed spc-rear camber kit/toe bolt and got alignment, how are my specs?
  17. Installed R1 Concepts rotors
  18. Installed G-Stechs - Lopsided? Passenger Rear higher?
  19. need brembo brake pads for non-brembo brakes?
  20. THMotorsports goes to 24 Hours of Nurburgring w/ KW Suspensions!!!
  21. Evo brembo fit on G35?
  22. Rotora rotors, go or no go?
  23. Ordering New Suspension Set-up - Need Help!
  24. Why have pillow ball tops on coilovers
  25. Which springs handle better?
  26. What springs handle better?
  27. Alignment?
  28. Endless RF-650 Brake Fluid - Explained
  29. IS this a good Setup?
  30. 2003 - 2005 G35 Brake Swap
  31. Clunking Sound from Drive Side Front.
  32. need quick advance on brakes/rotors...
  33. compression rod and dealer alignment question
  34. G Suspension Problems HELP
  35. Suggestions for lowering my coupe
  36. Can I fully drain brake oil?
  37. anyone have long tern use with tanabe NF210?
  38. Rear brakes dust, not the fronts
  39. My review of 04.5 350Z shocks on an 03 sedan
  40. 06 sedan on BC Racing coilovers
  41. bbk in 18inch wheels
  42. Time for BBK - need some advice.
  43. Thinking about a drop, but confused on what to do..
  44. Tube or Solid sways
  45. do you need to shave the area for the toe bolt on spc rear camber kit?
  46. when you get an alignment, will they know you have a camber kit and adjust it for you
  47. Z/G Procurement
  48. Total weight of a Rotora BBK needed
  49. 2005 brakes compare to 2008
  50. SAI angle?
  51. Ar-Kan Custom Powdercoated Subframe. Bored of bolt ons>?
  52. Rotor replacement - squeeking is driving me nuts!!
  53. project mu ns pads - where did you get them from?
  54. TEIN H-tech & S-tech setup
  55. spring/shock question
  56. Racing logic coilovers
  57. brake pads/rotors questions
  58. 3rd brake light resolution
  59. Anyone run Whiteline Sway Bars?
  60. Brake light on because of loose emergency brake...
  61. Pdr coating "hats" advice...
  62. do you guys swap out when snow comes around?
  63. Braided brake hoses for a '05 G35 coupe?
  64. Suggestions with setup
  65. how to lower your G properly!
  66. how much for a-arms???
  67. G35 sedan 6MT with some G37 shoes..
  68. Clunking from Front and Rear, what could it be??
  69. Airbag light after installing wheels?
  70. Front knocking/popping sound
  71. Vibration Problem from 65-80... Please help
  72. brembo conversion???
  73. bending a-arms to fix camber ?????????
  74. Novice needs some advice
  75. 03 G35 coupe parking break cable
  76. Stock 05 Coupe Alignment/Tire Wear issues
  77. Floor Jack Help!
  78. suspension, need some help and/or advice
  79. Need suggestions for aftermaket coilover.
  80. Advice on caliper color for new BBK on a DG Coupe...
  81. Measurement?
  82. pulp friction
  83. fix front camber without kit
  84. Is CAMBER KIT NEED'd?? HELP NEEDED.......
  85. Any issues with stance coils
  86. please direct me to tanabe distributor
  87. Lowering my car
  88. Spacer/ Fitment gurus. Chime in
  89. Clunking noise in trunk after installing coils?
  90. Will stoptech bbk from a 07 350z fit my 05 g35c??
  91. Stance GR+ (or other coilover) Camber Plates
  92. Problem installing rear Coilover/Spring need help
  93. 03 g35 suspension hits kinda hard want to upgrade but need suggestions
  94. Replacing Brembo seals?
  95. Richie's front strut tower brace
  96. Springs and Struts??
  97. 350z Stech's are on!!!
  98. cutting rotors after installing new pads
  99. Neg. Camber on stock height = Gayness
  100. Lowering