Projector Demon Eye Wiring Problems
#1
Projector Demon Eye Wiring Problems
I have a 2004 g, and just bought 06+ projectors took them apart painted them and installed a led in the projector housing for the demon eye effect. I tested the wiring off the car up to a 12V battery charger and they looked great. Put them in my car yesterday, wired it up and they are probably at least half as bright. This is how I wired them up.
From my battery I ran a positive into my car through the firewall where I have it going through a switch, and then back out through the firewall into a fuse where it then splits and goes to each headlight. Grounds are no more than 12inches long and go to bolts.
I then tried a wire right from the battery to one of the led positive leads and they were bright again! How can they be so dim? Is it because i'm splitting them?
Any help would be great. Thanks!
From my battery I ran a positive into my car through the firewall where I have it going through a switch, and then back out through the firewall into a fuse where it then splits and goes to each headlight. Grounds are no more than 12inches long and go to bolts.
I then tried a wire right from the battery to one of the led positive leads and they were bright again! How can they be so dim? Is it because i'm splitting them?
Any help would be great. Thanks!
#2
#3
connect to fog circuit, you can only use the demon when your headlight is on
Unless, you can turn on the fog without headlight on.
#6
Thread
Thread Starter
Forum
Replies
Last Post
zcherub
Engine, Drivetrain & Forced-Induction
1
08-30-2015 05:04 PM