TantoG35

yea the car is dropped on Eibach Prokits and with stock 04 shocks. the wheel is a stock 18 with the stock sized 225/45 on it.

the ride is a little rough, not sure if it's from 20s though. probably a combination of my suspension and thin tires. the roads in norcal are terrible too. i don't even bother going to sf with this car haha. i did need to get fenders rolled. to be honest, i wanted 19s but after 6 months these were the only ones for sale on the forums. go with 19s if you can.

thanks! they are work vs-xx. 20" 9.5 +17 front, 10.5 +17 rear. i'm dropped on sportlines, i think they at 1.75" lower than non-sport stock. in hindsight, i wish i got coilovers...

Data systems replica made by Eric

(STOPTECH BBK) I payed about $5,200 after taxes, front and rear rotors are 14"(355mm) and they make you pay extra for the cross drilled

my headlights are done from Clearcorners.com

http://clearcorners.com/products/infiniti/g35_1c/

I have Yellow H4 low/high beams as fog lights, 6000k (white not oem yellowish) HID replacement bulbs.

yeah if you don't want to go thru the wheelwell you either have to take off or drop the bumper..when me and my buddies put my projectors in we took off the 6 snap clips near the grill, 2 snaps on the inside of each wheelwell, then my bussy took off a couple nuts inside the bumper where you have to pull back the wheelwell to access. Then you just pull the bumper off and you got access to the headlights. Just be careful you don't scratch anything like your fenders as you move the bumper

its black vinyl put on the roof to make it look like its all glass. its available in the market place. i got mine done by a local sign shop. its an alternative to painting it, which some people do. this way if i dont like it or want to change i can just peel it off. it cost about 80 for the overlay then you have to pay someone to put it on because its pretty hard to do. the sign shop i used only charged me 70 total but i was the first they had done and they didnt think it would be as hard as it was.

Have you read this?

DIY Painting headlights

This is the guide I used when painting mine. Very informative and should explain everything

The paint I use is Krylon Fusion Gloss Black. You can find it at any automotive store.

Hope this all helps