Projector modifications
#1
#3
#4
The screws holding the lens are definitely very difficult to take off. Use a good screw driver. I had to put down just enough body weight on the screw driver so I don't ruin the screw.
There might have been red or blue thread lock there (don't remember now). I wonder if a thread lock remover or PB blaster may help.
Not sure what the purpose of painting the cutoff shield is. I do remember reading a post that there's a secondary shield that can be removed to get a sharper cutoff.
There might have been red or blue thread lock there (don't remember now). I wonder if a thread lock remover or PB blaster may help.
Not sure what the purpose of painting the cutoff shield is. I do remember reading a post that there's a secondary shield that can be removed to get a sharper cutoff.
The following users liked this post:
420OG35 (05-13-2013)
#5
Thread
Thread Starter
Forum
Replies
Last Post