F/S Stock Seven Spoke G35 Wheels Widened 2 Inches W/Very new Toyo T1R's!!!!!!
 

I have factory 2003 G35 7 Spoke 18" wheels and I had them cut and widened by 1 3/4"( so I could fit a larger tire on the vehicle(trying to keep the car looking stock), yet being able to put a larger tire under it to be able to help with the extra power the car was making.

Wheels are also powdercoated flat black. Wheels are in good condition, requires a little bit of weight to balance out(1-2 ounces of wheels weights when using stick on weights at two spots inside the wheels) and one wheel was very very very lightly curbed.

For the wheels to clear properly I believe they need a 10mm spacer in the front and a 15mm spacer in the rear(but I have never tried to fit them out without these spacers) which I am selling with the wheels and tires(tires are still mounted and I will not be separating the spacer, tires or wheels). The spacers are Ichiba and they require new wheel studs which you can buy from them for around $20 bucks I am told.

So here is what I have
(4) 18" 2003 G35 Wheels Widened 1 3/4" and powdercoated flat black
(2) 10MM Ichiba wheel spacers
(2) 15MM Ichiba wheel spacers
(2) 265/35/18 Toyo T1R's
(2) 295/35/18 Toyo T1R's

This is who did the work on the wheels http://www.weldcraftwheels.com/

Alone this whole set(tires, wheels, the cost to widen them, and the wheel spacers) $2850........I will be selling the whole setup for $1850 shipped ground in the basic 48 States or OBO(no legitimate offer will be refused)........now check out the pictures and if you have any questions please PM

where are the pictures?

+1 for pics

Must have been a sleeper! Post a pick. How much HP was the car at?

need pics!!!!!!!

Bump

Bump

pics!

These are the only pics I had of Jeff's car on my computer, but these wheels are sick!

http://i76.photobucket.com/albums/j2...i/IMG_4638.jpg

http://i76.photobucket.com/albums/j2...i/IMG_4000.jpg

Assuming from the post, but did you have all four corners widened?

Thanks

Chris

^Yeah, all four wheels are widened...

Thanks Chris for posting those up for me boss.....

bump.

Was browsing through their web and found this...
Basically 18" G widen and fit with 295/35/18
http://www.weldcraftwheels.com/Gallery2.htm
Scroll to Nick Jacob's Z
SIICK!!!

Ttt