![]() |
Problem with HVAC: Auto Temp control doesn't work
Hi All -
I am posting this because I am hoping there is an easy answer: Replaced the Bose HU with a Double Din Kenwood 7100. The radio is perfect - the HVAC auto temp isn't working. I have two settings: 60 Degrees: Full COLD 61 Degrees (on up) - Full HOT. It is like it is missing the internal temp thermometer - so it assumes it is freezing and tries to heat the cabin as fast as possible... The other buttons work: mode - ac - defrost - fan, etc. My car came with the Dual Climate Control - but the replacement HVAC board didn't have that button on it... Ideas? Am I missing something easy - or do I replace the HVAC controls again (just a bad board???) Thanks in advance guys: -Daniel PS> If this is the wrong section - feel free to move it. I have no idea where it should go... |
undeneath the steering wheel, there is a panel that sits right above your knees. there is a sensor that you forgot to reconnect before you put it back together.
|
^ Right. There is a tube and a white connector on the right side of that panel. You probably forgot about them.
|
Originally Posted by kyu1021
undeneath the steering wheel, there is a panel that sits right above your knees. there is a sensor that you forgot to reconnect before you put it back together.
Thanks guys - will let you know if it works. -Daniel |
Originally Posted by DWeidman
Great - I will check this afternoon.
Thanks guys - will let you know if it works. -Daniel The installer apparently missed it - glad I have this forum to clean up after the professionals. ;-) Thanks again, seriously, I appreciate it. -Daniel |
What's the cause if the in-cabin sensor is connected properly?
|
I guess I have to bump this thread. I just had an Ipod connection and new front speakers installed. Noticed on the way home I have cold air at 60, hot at 61 and up. I looked for any unconnected wires and didn't see any. Did I need to remove any panels under the steering wheel or should it be right in front of me?
Thank you in advance. I actually had nightmares about having this work done, kept stressing something would get scratched or broke. Everything checked out fine before I left the shop...of course the one thing I didn't check isn't working. Lisa |
Disregard my previous post...I found the DIY and fixed it.
Lisa |
| All times are GMT -4. The time now is 04:00 AM. |
© 2026 MH Sub I, LLC dba Internet Brands