Ichibia Rear Camber Kit???
#16
#18
#20
Can you explain to me then how you can get additional adjustment of the spc/ichiba toe bolts without elongating the hole when the OEM eccentric toe bolts already cover the whole range of the stock hole? Post the ichiba toe bolt instruction sheet where it says you DON'T need to elongate the toe bolts
#24
That is because they ARE SPC TOE BOLTS. So not explain how by magically changing the name on the box to ichiba, they can now make their full range of adjustments, while the box labeled SPC cannot, even though the bolts are the same....
#25
That can be done with stock toe bolts. I want alignment numbers and drop amount. Otherwise I call BS. Even without toe bolts and a 0.9" drop, I was able to get my car back to OEM specs, so you are still not proving your point.
#26
Registered User
iTrader: (2)
Join Date: Jan 2008
Location: AZ
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
Whoa, so they are boxed as ichiba , is this because SPC sells their products mass assortments out to other companies , I see your getting a little heated on this it's ok , I did this on 3 cars and they had no problem when getting aligned, even without elongating it the alignment shop was still able to adjust the toe thats all I'm saying
#27
Registered User
iTrader: (2)
Join Date: Jan 2008
Location: AZ
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
As far as proving points I really wasn't trying to you can call it bs or shenaningans or whatever , it dont matter , I never said it was back to full oem specs , I said close that it could be to oem specs, I'm pretty sure its not dead on , Redlude I'm not here to fight or prove points
#28
Whoa, so they are boxed as ichiba , is this because SPC sells their products mass assortments out to other companies , I see your getting a little heated on this it's ok , I did this on 3 cars and they had no problem when getting aligned, even without elongating it the alignment shop was still able to adjust the toe thats all I'm saying