OEM 19's flush offset (pic request)
 

Guys please advise me as to what springs to go with (getting coilovers maybe next year) to get a 1/2finger to no gap at all drop, and also what spacers to go with, and how wide to make the OEM 19's sit flush, and I want to stretch the tires a tad bit so I don't have to roll my fenders, any advice?

I have a OB coupe 6mt 2007, and so far, RawFusion's car looks amazing...

please post up pics and specs!!

Kevin

You need to do some searching, there is a thread with 15/20/25mm spacers in various combos with plenty of pics. I have 25mm all around and it is a HUGE improvement over stock but if I were to do it again I would do 25/30. As far as a no finger drop with just springs, that is asking a lot. You would probably need tanabe's to even get close to what you want. Plus then you will need new struts really soon, not to mention camber kits. Might as well just buy the coilovers now and save yourself money down the road.

thanks man...I'll do more detailed searches next time..

how about a one finger gap? would that kind of spring be soft enough to get the struts to last me a little longer? what coilovers are cheaper than tein basics? and good quality of course...

thanks a lot!!

Kevin

if you want to go that low on springs, the spacers will not be flush without a camber kit and a fender roll in the rear. i had my car at a drop a little more than the tanabe df210s and i had about a 10 mm spacer between fender and wheel WITH my 30 mm spacers on.