*dyno* results!! 2005 G35C 5AT w/ HKS and AEM CAI
2 Attachment(s)
I put my G35C 5AT on Church's Dynapack 2000 last Saturday for a semi-baseline. I never thought about getting a stock baseline because *initial* plans only included an intake and cat-back....:p
As my sig shows, I've got an AEM CAI and an HKS Hi-Power. I know the CAI won't do much for me until the car gets tuned (prob TS). On the attached hp and torque curves, the high curve is the third pull. The guy doing the test decided to remove the AFR sensor tube from my left exhaust and found it was restricting me ~13hp. Peak HP: 264.7 (stock 5ATs run 245-250 on that dyno) Peak torque: 246.1 From here, I'm putting on a Crawford plenum and then probably headers. I'm still contemplating the headers because I don't want to lose any low end. Any comments?? (The AFR plot reads 1 high, so where it reads 14.0 on the plot it's actually 13.0) |
good...bad...am i just a geek?...anyone?
|
seems about right. i dynoed 279/257 there
|
I'd like to know more about the removed sensor adding 13 hp???
Does that throw a CEL? |
Originally Posted by rcdash
I'd like to know more about the removed sensor adding 13 hp???
Does that throw a CEL? It didn't throw a CEL, as I recall. I did get some warning lights but that was from having the back wheels spinning and the front ones still. |
You won't lose tq with headers, if anything you will gain!
|
All times are GMT -4. The time now is 10:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands