maxflow race bypass valve o ring
#1
maxflow race bypass valve o ring
I have a o7 w/ V3 Vortech supercharger and for some reason i can't get my boost gauge to read past 3 psi. I've checked all the piping and the plenum area no leaks that i can find. However, i did remove my bypass valve and realized that the o ring is not quite sitting properly. In other words, it's like it's a little too big for the groove. Has anyone else had a similar issue. Again, i'm not saying it is the o ring it was just an observation. Any help would be appreciated and yes i'm looking into getting a new o ring and see.
Thread
Thread Starter
Forum
Replies
Last Post
liche
Engine, Drivetrain & Forced-Induction
1
09-19-2010 05:43 PM