|
Is it going to cause big problem?
Today, I cleaned the throttle body using the Sea Foam Deep Creep. While I had the butterfly valve open, I tried to spray the solution and the red plastic straw flew off inside the throttle body. I could not see or get this plastic straw out. So, I put everything back and drove around without any issue. Does anyone have any idea if this going to cause problems later on? Thanks for any advice.
|
^wth?!? isn't going to melt in there??
|
ARE YOU SERIOUS?
Oh Gaaaaaaaaaaaaaaawd! |
Originally Posted by colsoh
(Post 4976759)
I could not see or get this plastic straw out. So, I put everything back and drove around without any issue.
https://www.motifake.com/image/demot...1250769688.jpg |
|
Almost sounds like a setup for a joke. I hope it's not.
|
WTF pull your IM off and get that thing out of there, what is wrong with you, do you seriously think that's OK:confused2:
|
Originally Posted by DamnYankee
(Post 4976842)
Almost sounds like a setup for a joke. I hope it's not.
|
It's probably stuck inside the intake plenum. Open it up by taking off the bolts up top and around and find out.
|
It's fine to leave it in there,wait and see if the engine blows up. It should be easy to reach it when rebuilding the block.:rolleyes:
|
You need to get it out dude.
|
now come on....why would you even as if its going to be a problem?
Yea, it might hinder your motor a tad....I mean you might be new and all, but come on. |
I don't think it's wise to leave that in your plenum, those straws are small and could end up anywhere. Take the time to pull the top off your plenum and get it out....shouldn't take an hour if you take your time.
Gary |
it would be best to get it the hell out of there! not a hard job!
|
I concur.
|
| All times are GMT -4. The time now is 03:52 AM. |
© 2024 MH Sub I, LLC dba Internet Brands