G35Driver - Infiniti G35 & G37 Forum Discussion

G35Driver - Infiniti G35 & G37 Forum Discussion (https://g35driver.com/forums/)
-   G35 Coupe V35 2003 - 07 (https://g35driver.com/forums/g35-coupe-v35-2003-07-14/)
-   -   DIY: TPMS sensor reset (https://g35driver.com/forums/g35-coupe-v35-2003-07/407895-diy-tpms-sensor-reset.html)

onthe3rdday 05-21-2012 11:50 AM

DIY: TPMS sensor reset
 
5 Attachment(s)
I ate a curb last night and cracked my LF rim :( I went to NY and grabbed a set of rear 18's and moved my rear 17's up front. I had to reset the TPMS system afterwards to get the system to recognize the new sensors.


Procedure:
Set the tire pressures to the following values

RF34 RR26
LF31 LR28

Locate the TPMS Service connector by doing the following:
Remove the plastic panel directly below the steering wheel (you must remove two other panels to get to it), and taped to the OBD harness is the TPMS Service connector

Attachment 243557

Feed the service connector through the OBD2 data connector opening and then replace the plastic panel.

Back-probe the service connector with a paperclip or something similar, I used one of the probes from my meter.

Attachment 243558

Start the engine.

Ground the service connector to the chassis 5 times, about once per second.

Your TPMS light will begin flashing

Attachment 243559

Take a 5-5.5 mile drive and your TPMS light will turn off.

Immediately refill the tires to the recommended pressure... in my case 35psi. If you do not, the sensor will alert you with an annoying high pitched beep. Enjoy your dash with no TPMS light!!!

Attachment 243560

Attachment 243561

dukehotty 05-21-2012 09:04 PM

Awesome! I love this forum!

Frankieg35 05-21-2012 09:11 PM

Nice writeup.. why didn't u get a full set of 18s though??

dukehotty 05-21-2012 09:13 PM

Hey Frankie someone mentioned you in a recent thread.
https://g35driver.com/forums/brakes-...ml#post6458243

Frankieg35 05-21-2012 09:44 PM

Lol why all the h8!?! Don't be mad!! Lmao

onthe3rdday 05-21-2012 10:19 PM

My 17s are in better condition and are wider. Temporary setup.

Eye Eat Ketchup 06-11-2012 11:40 PM

where did you ground the service connector? Is it long enough to reach part of the chasis?

onthe3rdday 06-12-2012 07:32 AM

I removed the plastic fuse box panel on the left, grounded on one of the openings that the panel clips in to

YOG35C 07-05-2012 01:30 AM


Originally Posted by onthe3rdday (Post 6457593)
I ate a curb last night and cracked my LF rim :( I went to NY and grabbed a set of rear 18's and moved my rear 17's up front. I had to reset the TPMS system afterwards to get the system to recognize the new sensors.


Procedure:
Set the tire pressures to the following values

RF34 RR26
LF31 LR28

Locate the TPMS Service connector by doing the following:
Remove the plastic panel directly below the steering wheel (you must remove two other panels to get to it), and taped to the OBD harness

Feed the service connector through the OBD2 data connector opening and then replace the plastic panel.

Back-probe the service connector with a paperclip or something similar, I used one of the probes from my meter.



Start the engine.

Ground the service connector to the chassis 5 times, about once per second.

Your TPMS light will begin flashing
]

Take a 5-5.5 mile drive and your TPMS light will turn off.

Immediately refill the tires to the recommended pressure... in my case 35psi. If you do not, the sensor will alert you with and annoying hig
h pitched beep. Enjoy your dash with o TMPS
l4184/2012-05-21102055.jpg[/IMG]

Wow, you must be some kind of hacker...lol good write up. 53/100

G_DiRTY5 05-31-2013 12:12 PM

Don't really know how to sub without commenting. :dunno:

Shawno72 12-02-2013 12:15 AM

Good info

Mustang5L5 12-02-2013 09:02 AM


Originally Posted by YOG35C (Post 6503317)
Wow, you must be some kind of hacker...

Its the procedure outlined in the FSM.

I've done this method a few times with success.


They actually make a tool for grounding the test plug. Not really necessary, but does make it slightly easier. You can probably make your own wire harness for $1 to do the same thing


COBRA ESQ 12-27-2013 05:34 PM


Originally Posted by dukehotty (Post 6458240)
Awesome! I love this forum!

QFTT !! Gonna give it a try (I assume it is the same for sedans?)

Urbanengineer 12-27-2013 05:38 PM

Yeppers.

Urbanengineer 01-10-2014 10:48 AM

Google this, but why can't any TPMS sensors work for any car?

Simply amazon has a set of generic TPMS sensors for 50$, but the best value infiniti/nissan equivalent is 100$.


All times are GMT -4. The time now is 10:50 AM.


© 2019 MH Sub I, LLC dba Internet Brands