ConceptZ 3/8 Plenum Spacer Installed
#1
ConceptZ 3/8 Plenum Spacer Installed
Had a bud that gave me a ConceptZ 3/8 plenum spacer a couple years ago and it's been sitting in my garage. Why you ask? Well, no real excuse other than being too busy with work, etc. Today was the day...
At first impression I have to say that it's a bit underwhelming. I did notice some faint low end punch from the seat dyno, but nothing earth shattering. All in all, in installed easy and ran mostly like normal, which is good in that I had no residual issues from the install.
SO, I did unhook the battery to reset things, but I could never get the ECU reset to work like the instructions outlined in the Motordyne install guide.
Should I give it a bit to see how it goes? Or attempt the ECU reset again? I wasn't expecting much, but I'm having a hard time even detecting that anything changed.
At first impression I have to say that it's a bit underwhelming. I did notice some faint low end punch from the seat dyno, but nothing earth shattering. All in all, in installed easy and ran mostly like normal, which is good in that I had no residual issues from the install.
SO, I did unhook the battery to reset things, but I could never get the ECU reset to work like the instructions outlined in the Motordyne install guide.
Should I give it a bit to see how it goes? Or attempt the ECU reset again? I wasn't expecting much, but I'm having a hard time even detecting that anything changed.
#2
#3
#5
Registered User
iTrader: (10)
All bolt on's plus an Osiris tune = noticeable increase and fun ride!
Spacers, plenums, intakes, exhaust none of these will give you major noticeable increase in whp until you combine them all with high flow cats and a tune. HFCs alone are worth 7+ whp and a tune 25 to 30 plus additional 18 to 20 lbs. torque!
Gary
Gary
#6
#7
Trending Topics
#8
It's still back-ordered if you are still interested, no production time either. Ended up going with the Tanabe Medallion.
Thread
Thread Starter
Forum
Replies
Last Post
2014g35x
G35 Sedan V36 2007- 08
3
03-17-2016 10:02 PM