G35Driver - Infiniti G35 & G37 Forum Discussion

G35Driver - Infiniti G35 & G37 Forum Discussion (https://g35driver.com/forums/)
-   Interior & Exterior (https://g35driver.com/forums/interior-exterior-21/)
-   -   one of the hid's is out (https://g35driver.com/forums/interior-exterior/405483-one-hids-out.html)

G37_SOME Apr 17, 2012 06:33 PM

one of the hid's is out
 
hi guys i need some help asap as the car is my mothers daily driver. its an 04 g35 coupe that has had the healights converted by the previous owner to 06 lights. just last night one of the lights no longer turns on so the one thing i have done so far is swapped the bulbs from left to right and right to left. well now the light that wasnt turning on comes on, and the one that was working now doesnt since i have switched side. my question is what would be the most likely cause of this problem. ive gone back over and made sure al the connections where tight and plugged correctly. any help is apreciated.

.cakestar Apr 17, 2012 06:56 PM

.............wouldnt this be obvious that the bulb is out? or is there some key point im not understanding?

G37_SOME Apr 17, 2012 06:58 PM

i wish it was that easy.. the bulb that appeared to be out, when i switched it to the other side now lights up so its not the bulb.

.cakestar Apr 17, 2012 07:00 PM

ohh i thought you were saying that once you switched it, the other side went out... so you are saying that even after switching, the headlight that was not turning on is still not working correct? are the fogs working on the side that is out? driving lights? figure out if its the ballast or maybe the actual igniter.

G37_SOME Apr 17, 2012 07:04 PM

the light that was not working, once switched to the opposite side now works.. all other lights turn on. i just dont know if its the ignitor or the ballast.

.cakestar Apr 17, 2012 07:15 PM

Take a look at the igniter see if there is any type of gunk buildup where it connects to the bulb, I had a little bit happen with mine.

G37_SOME Apr 17, 2012 07:24 PM

ill check that out.. is there any way to diag wich would be bad? the ignitor, the ballast or worse yet both?

.cakestar Apr 17, 2012 07:29 PM

i dont know of any way to do that without physically taking them out and actually swapping the igniters with the ballasts to determine, maybe someone with more headlight experience could comment.

G37_SOME Apr 17, 2012 07:30 PM

i appreciate your help.

SuperCleanG Apr 17, 2012 07:32 PM

Prolly the ballast or igniter.. take them out and look at the wiring and chk the continuity


All times are GMT -4. The time now is 12:05 PM.


© 2026 MH Sub I, LLC dba Internet Brands