G57 Sedan Build Thread
#77
The following 2 users liked this post by G35Drew:
Blue Dream (03-31-2018),
cleric670 (03-30-2018)
#78
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,487 Likes
on
1,222 Posts
G35 sedan w/ too much money in mods
#79
#80
#81
Nothing crazy to report. Life happens so I haven't gotten much done. The weather is warming up nicely so should be able to put more wrench time in. Got the ATI balancer torqued on. 235 lbs sucks. I sandwiched my left ring finger between the torque wrench and the frame when the drill bit I was using to hold the flywheel still slipped 🙄 probably gonna lose that fingernail.
#83
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,487 Likes
on
1,222 Posts
G35 sedan w/ too much money in mods
#85
Got the summer tires mounted. 265/40/18 on 18x9.5 +38 out back and 235/45/18 on 18x8.5 +35 up front
Couldn't find a pretty place to run the heater hoses.
Decided to start wrapping the headers once they were already installed 🤦
Didn't like the factory terminals so I installed these mil-spec ones and a distribution block for the positive terminal
Couldn't find a pretty place to run the heater hoses.
Decided to start wrapping the headers once they were already installed 🤦
Didn't like the factory terminals so I installed these mil-spec ones and a distribution block for the positive terminal
#86
#87
#88
I think the supposed low mileage GTO trans is trashed. I can only get it into 4th, 6th, and reverse when the engine is running. Luckily the engine/trans is easy to yank back out. When I return from vacation I'll pull it, see if anything looks wrong with the clutch, and possibly think about a level 2 rebuild if needed. I need to wrap the headers anyways, so it's not a huge deal to pull the motor
#89
Join Date: May 2017
Location: Washington State
Posts: 14,817
Received 2,473 Likes
on
2,164 Posts
Coupe 6MT Premium RAS
#90