G35Driver - Infiniti G35 & G37 Forum Discussion - Search Results
Show Your Support Become A Premier Member



Showing results 1 to 25 of 117
Search took 0.05 seconds.
Search: Posts Made By: coffeysm
Forum: G35 Sedan V35 2003-06 07-26-2018, 12:22 PM
Replies: 2
Views: 194
Posted By coffeysm
It could be this grommet located in the fuel pump...

It could be this grommet located in the fuel pump assembly:

https://www.z1motorsports.com/fuel-pump-and-control-unit/nissan/oem-fuel-pump-grommet-p-8376.html

It could also be your sending...
Forum: The G-Spot 07-10-2018, 02:36 PM
Replies: 15
Views: 466
Posted By coffeysm
The way your car works is when it's cold (sitting...

The way your car works is when it's cold (sitting overnight, engine cools down) it starts up in something called "open loop". This means it runs in a rich mode (more fuel added) to help with...
Forum: G35 Sedan V36 2007- 08 07-04-2018, 01:22 PM
Replies: 13
Views: 314
Posted By coffeysm
I had an issue with an ac compressor on a Volvo I...

I had an issue with an ac compressor on a Volvo I used to own. The gap would be within spec on medium temp days and on real hot days it would work temporarily. It was due to the extra heat causing...
Forum: The G-Spot 06-29-2018, 05:30 PM
Replies: 15
Views: 466
Posted By coffeysm
Does it start on the first time with the MAF...

Does it start on the first time with the MAF disconnected and then go back to how it was when you plug it back in?

I'd look for a vacuum leak, throttle body (tps or idle air control), maybe your...
Forum: The G-Spot 06-28-2018, 10:43 PM
Replies: 15
Views: 466
Posted By coffeysm
Try starting the car without the MAF connector...

Try starting the car without the MAF connector plugged in. It will set a code, but should run really rich and limp mode. If that works you can narrow the fuel out and look at too much air getting...
Forum: The G-Spot 06-28-2018, 03:33 PM
Replies: 15
Views: 466
Posted By coffeysm
It could depending on how fast it loses pressure....

It could depending on how fast it loses pressure. When you turn the key to the on position it usually primes the rail for one or two secs with fuel (try turning it on/off several times and then...
Forum: The G-Spot 06-28-2018, 01:24 PM
Replies: 15
Views: 466
Posted By coffeysm
How long has it been sitting between your...

How long has it been sitting between your restarts? It could be your fuel pump not maintaining pressure in the rails.
Forum: G35 Coupe V35 2003 - 07 06-25-2018, 10:45 PM
Replies: 6
Views: 245
Posted By coffeysm
Update: My leak was definitely coming from...

Update:

My leak was definitely coming from the passenger side rear axle diff seal and that whole side was covered in grime, gear oil, and dirt. To remove the flange I used a long pry bar and...
Forum: Engine, Drivetrain & Forced-Induction 06-20-2018, 05:11 PM
Replies: 3
Views: 257
Posted By coffeysm
Just Fixed My RAS

I couldn't find a G35 RAS assembly, so I purchased one from an M35/M45 vehicle. Has a completely different part number: 55705-AQ500. It bolted right up and my problems went away. It cost me about...
Forum: G35 Coupe V35 2003 - 07 06-16-2018, 12:21 PM
Replies: 1
Views: 181
Posted By coffeysm
If the A/C switch is off the high speed won't...

If the A/C switch is off the high speed won't turn on until the temp reaches 212.

A/C switch on < 50 MPH and A/C PSI < 229.1 the high speed will not turn on until 212 as well.

If A/C switch is...
Forum: G35 Sedan V35 2003-06 06-02-2018, 10:35 PM
Replies: 15
Views: 707
Posted By coffeysm
I'd try some heat or impact gun if you can. You...

I'd try some heat or impact gun if you can. You don't want put too much torque on something that hasn't been taken off in a long time. I believe there were a few members here who had the stud break...
Forum: G35 Sedan V35 2003-06 04-20-2018, 03:07 AM
Replies: 9
Views: 535
Posted By coffeysm
If you have < 07 he should have the access panels...

If you have < 07 he should have the access panels and not have to remove the front cover. My water pump went out a few years ago and I changed it myself. However, you have to move the crank a...
Forum: Car PC 12-04-2017, 10:05 PM
Replies: 18
Views: 1,400
Posted By coffeysm
I didn't read your post all the way through and I...

I didn't read your post all the way through and I highly suspect your assumption is correct. You might want to look into getting a new CV axle if it's been spitting grease everywhere. Raxles.com is...
Forum: Car PC 12-04-2017, 09:55 PM
Replies: 18
Views: 1,400
Posted By coffeysm
Here is C1105 from AllDataDIY.com Your...

Here is C1105 from AllDataDIY.com

Your Vehicle: 2006 Infiniti G35 Coupe V6-3.5L (VQ35DE)

Vehicle A L L Diagnostic Trouble Codes ( DTC ) Testing and Inspection C Code Charts C1105
...
Forum: G35 Sedan V36 2007- 08 11-27-2017, 11:48 AM
Replies: 14
Views: 729
Posted By coffeysm
The U1000 I think usually means when the BCM...

The U1000 I think usually means when the BCM can't talk to the other modules for a few seconds. I'm guessing your BCM is having issues talking to the IPDM and getting the status of your steering...
Forum: G35 Coupe V35 2003 - 07 11-24-2017, 12:52 AM
Replies: 14
Views: 614
Posted By coffeysm
I believe there are two of them. The one on the...

I believe there are two of them. The one on the left is easy to see and the other one is hidden underneath somethings I believe.
Forum: Engine, Drivetrain & Forced-Induction 10-27-2017, 01:19 PM
Replies: 7
Views: 394
Posted By coffeysm
It could also just be your water pump bearings...

It could also just be your water pump bearings going out or another bearing noise. I took my belts off and revved my car in the driveway to isolate everything except the actual engine itself.

But,...
Forum: Engine, Drivetrain & Forced-Induction 10-27-2017, 12:11 PM
Replies: 7
Views: 394
Posted By coffeysm
If you listen at 4:50-4:55 where he talks about...

If you listen at 4:50-4:55 where he talks about the engine popping and rotating during the water pump job he's absolutely correct. That's what happened to me when I went to do my water pump on my G...
Forum: Engine, Drivetrain & Forced-Induction 10-26-2017, 09:11 PM
Replies: 7
Views: 394
Posted By coffeysm
I replaced my timing chain on my 06 5AT I don't...

I replaced my timing chain on my 06 5AT I don't imagine the procedure is much different. The upper oil pan can stay on and you only take the lower off, because there is two hidden bolts. Pop off the...
Forum: G35 Sedan V36 2007- 08 10-24-2017, 11:26 PM
Replies: 10
Views: 927
Posted By coffeysm
They run at low speed if one relay is turned on...

They run at low speed if one relay is turned on and they are supposed to run at high speed when the ecu turns all three relays on I think( I forget). Both fans should be on high speed when the ac is...
Forum: G35 Coupe V35 2003 - 07 08-23-2017, 11:58 PM
Replies: 24
Views: 1,012
Posted By coffeysm
Yea, that radiator fan took them at most an hour...

Yea, that radiator fan took them at most an hour to remove. You drain some coolant, unscew a few bolts, and loosen the A/C line and it pops right out. I swapped mine out in about an hour and 15-20...
Forum: G35 Coupe V35 2003 - 07 08-23-2017, 01:57 PM
Replies: 24
Views: 1,012
Posted By coffeysm
Wow, they really screwed you. You could have...

Wow, they really screwed you. You could have done the fan yourself for 100 bucks just by purchasing a new fan.

Did they tell you what part of the caliper is locked up? Is it the guide pins,...
Forum: Engine, Drivetrain & Forced-Induction 08-18-2017, 07:08 PM
Replies: 9
Views: 3,886
Posted By coffeysm
Looks like maybe the radiator had a seepage leak...

Looks like maybe the radiator had a seepage leak along the bottom of it also. Mine was the same way and I replaced it as well. I think over the years the gasket and plastic get brittle and just end...
Forum: New Members Check In 08-18-2017, 10:51 AM
Replies: 18
Views: 740
Posted By coffeysm
Here's a link to the FSM:...

Here's a link to the FSM: http://www.nicoclub.com/FSM/G35/ it will have all the info that dealer techs use and it's free.

Which fusible link are you blowing? The big one right on the battery?
...
Forum: G35 Sedan V35 2003-06 08-17-2017, 11:52 PM
Replies: 4
Views: 438
Posted By coffeysm
I would say maybe he's looking at the thermostat...

I would say maybe he's looking at the thermostat housing?

It could be a gasket, clamp, or crack in the housing. Yes, you can replace it yourself.
Showing results 1 to 25 of 117

 
Forum Jump

All times are GMT -4. The time now is 05:14 PM.


© 2018 MH Sub I, LLC dba Internet Brands
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.