this is the factory bose "crossover" right?
#1
#2
There's no crossover, just a split in the wiring. The factory tweeter uses a capacitor to block lower frequencies. If that only goes to the tweeter location and to the stock speaker harness, then go ahead and remove it. Worst case, you solder it back in place later.
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM
Ninjay16
Audio/Video/Electronics
11
02-26-2018 06:14 PM
DEMoLITIoN
Audio/Video/Electronics
8
04-20-2016 06:57 PM