Hey guys and gals. Up for sale is a used kit that I bought recently. I never installed it but was going to until a very good offer came up. So now it's for sale again. I had a switch and bottle brackets damaged during shipment, but I replaced the bracket with new ones and I'll eat the switch. I also sent the solenoids (Fuel, Nitrous and Purge) to NX to have them looked at and all had a clean bill of health. I will include the invoice for you (2/26/07). The kit is as follows:

NX Fuel Solenoid
NX Nitrous Solenoid
NX Purge Solenoid
NX Noz pressure sensor with gage
NX Next Gen Bottle Warmer
NX 10lb Bottle (Half Fullish???)
Nos remote bottle opener
Nos Fuel pressure safety switch
Brand new bottle brackets
Fuel and Nitrous Lines
NX Nitrous Nozzle with Jets (1x26, 2x28, 2x52) approx 125 shot
A lot of mixed switches, relay and a bunch of fittings
Fuel tap (looks like it will work)

There is some instruction of a basic kit but you can order a complete instruction manual from NX if you need to ($15). All you need to do is add activation switch (window switch)and a couple more relays and use the switch box in the kit and you're ready to go. You can also buy different jets for about $4 a piece. As stated above, this is a used kit so some of the parts have minor scratches on them (from wrench's etc...). I'm asking $500 shipped to you in the 48 states. Thanks for looking.

 

Bump

 

Mid week Hump Bump.

 

Taking offers. Low ballers not needed!!!

BTW relays can be had for $15 a pop.

 

What you'll need for this kit is really up to you. How fancy do you want to get??? See pic's for a basic wiring diagram that's a simple of a system as you can get. I also included some one for the purge system as well. NX's website has all the system's instructions free online for you or you could order you're own for $15. If stuck call Josh at NX. Even Craig (he did my solenoids) that does their warranty work, is a wealth of knowledge. Don't think you'll be stuck not knowing how to make it work. There is also guys here that know there "Poop", give them a PM. I'm sure if you ask nice they would be more than happy to help. As for what you'll need, well you'll need to activate this by way of a WOT switch or Window switch. Relays can be had at NX but Josh told me to just go to Radio shack and pick up 40amp relay.

So really it's up to you. If it were me, I'd get Dynotune's switch center and wire that in or you can use the switch center in this kit. Now that I rambled you'll need:

(1) Activation switch for all items (System, purge, bottle opener and warmer)
(2) Relays

Newbs: Have a look at NX's site. (Main page, left side were it says "Instruction manuals") Great place to start. Get this kit, put you're foot to the floor............ and hang on!!!

 

SOLD