considering parting out the motor i am building... i have put a lot of money into this and i want to go to school, so all my goodies need to go, including the car.

Anyway, about the heads, I had them professionally ported by my machinist that has recently retired, nothing but top notch work from him. I had him clean up the intake ports and do some bowl work. The intake split is knife edged. Exhaust ports were also cleaned up and polished.

While he was in there he installed the JWT valve springs and shims.

All of the lifters/cam buckets are the correct height for a cold lash of .010"-.013" with the C2 cams.

Cams themselves are 261/261 duration, and have .456"/.456" (11.5824mm) lift
http://www.jimwolftechnology.com/cus...asp?PartID=461

I would be lookinng for ~$2000 shipped for these guys..

 

I'm interested but since you are so new I would need some kind of way to make sure I don't get burned.

 

where are you located?