where are you located

 

only if these were black....

 

PM sent

 

San Francisco / Bay Area

 

would these fit over the factory brembo, if so please pm. I am located in Los Angeles.

 

On my set of GT-Forces what i did was tape off the inside part of the lip and refinished the trim of the lip where it was curbed... to the naked eye you couldnt even tell the diffrence between the anodized inside and the polished trim... i had to point it out to people... you just have to be careful when sanding so you dont scratch the inside part of the wheel...it can be done just depends on how **** you want to be...FYI...

*on another note i wish i had the cash... i would pick these up in a heartbeat!

 

I want this wheels baddd wish I had the Money

 

i'm sure these will fit brembo...i had 20x9 +23 in the front and still need 5mm spacer. +18 shouldn't be a problem

 

the front maybe being 9.5 wide. the rears are 11 wide. so that might be a problem. the rims in the back are almost perfectly flush with the body. you may need to adjust the camber more negative in order for these not to rub.

 

I was just getting ready to shoot you a PM on these!

 

dont people understand yet that offset doesnt have anything to do with brake fitment.....its the disk that matters, not offset. brake clearance is determined by the type of disk aka the center, of the wheels is made with

 

would you do 3000 shipped?

 

i think 3000 shipped + oem 19's = ~$3800

kinda high IMO, esp considering curb rash.

I don't want to low ball you but 2,000 + OEMs?

 

E-mail Sent..

 

Do you still have these?