FS is a Tanable Ypipe used for <2mths on a weekend car.

Got it new for north of $500 USD shipped to my doors:
http://www.mynismo.com/products/?id=2952

I am asking for $290, OBO, local pickup in Toronto only

There is nothing wrong with this ypipe at all, I am going into a setup that will eliminate the need of a traditional Y.
See below if you want to learn more about why I went with Tanable:

Tanable merge collector:
2.75" ID instead of 3" in most afteramarket Y (which is too large for OEM midpipe)


OEM merge collector, notice the design (use of cast iron crush collector) and quality of weld:



It is made in Japapn!

let me know if you decide to ship to socal

All PMs replied, I am willing to ship and work with the buyer on shipping cost if I can't sell this locally within the coming days.

god i need this but so broke

did you notice any performance gains and how was the sound after this mod??

Sorry for the late reply.
This was more of a performance mod that will allow you to start modding from the front to the back; always remember that you should start from the front to the back (not the other way round), and the ypipe is as front as you can go unless if you are touching cats/ headers.

For performance, I didn't do any dyno after this mod, so I cannot tell you any absolute #s. However, I do feel better pull above 4k rpm and a deeper sound throughout the RPM.

Another reason that I went with this was that this pipe was a good 7+ lbs lighter than the oem pipe =)

Hope this helps

***
Replied to all pms, but sorry, I do not consider any trades.

^oooh k thanks for the reply