Well today i ran my power wire to the trunk and started to dynamat the doors. I'm waiting for my spacers to come on tuesday before i can install the front comps, up6's. I was wondering where eveyrone mounted the crossover? Also how did you guys mount it on the door? It seems like the crossover has 4 holes if you take off the cover. Did you guys use those holes and a set of screws? Those holes seem mightily close to the circuits inside, not too sure i'm suppose to be messing w/ those. Any tips or pics would be great. Thanks.

 

I'm sure elduderino could point you in the right direction

 

hmmm anyone?

 

I did double sided tape where the foam used to be.

 

I put mine in the doors (all 4). The crossovers for the eclipse speakers were pretty big but I still managed to get them in a position where the door panel could go back on without any trouble. I used screws to anchor them.

 

I have mines installed where the old bose amp was located.

 

I don't have UP6 but my crossovers are in the doors, taped in there.

 

My UP6 crossovers are in the doors. If you can find the install thread by myself or el_duderino there is a link to some pics.

 

yeah i tried searching but the install thread didnt have the pic of the crossover...its ok i finally found a sweet spot for it that barely fit. btw, i am planning on keeping the stock HU (for now), i just finished installing the comps in the front, still need to install the amp tomorrow nite. Hopefully it will sound way better when its done because right now it sounds really crappy, hopefully its due to the equalization and lack of power from the blose. i'm gettin a nice sounding bass though.