well here it is:


I got all the goodies too!

Question for the those who have this model or similar DD's

How do you get the black trim peice that comes with the DD to fit inside the JDM DD dash? Mine is about 1/8inch to big to fit.


as you can see when you try and fit the black trim behind the dash kit its too big...



do i just sand down the fit kit that came with the DD? Or do i have the wrong one?

 

also, where did everyone mount their rear camera, the antenna for sirius, and the mic for the voice recognition.

 

Dremel makes everything fit.

Seal it into place with hot melt glue. High temp, or it'll fall off in the summer heat.

 

i mounted my rear cam to the license plate, dont have sat radio with my setup, and i mounted my mic in the same place as stock.

 

My installer mounted the mic up by the card slot above the door. Didn't do Sirius.

 

I put the mic so it sits between the sunglass compartment and the rear view mirror. It works great to pick up both passenger and driver.

 

excellent spot!

 

How the installation go?

 

didnt get around to it today bad weather and so much work. Ill get it on friday and post pics of install!

 

well guys i got some done today, haha. I was able to remove the OEM radio very easy in about 15min.

I was able to put together the new radio and new DD dash trim kit together also, with some modifications to make it flush.

heres the babe sitting in the living room

 

Now comes the tricky part...i know how to install the sirius, the navi, the ipod cable, the mic, and a few other misc things, but here are the wires i dont know how to install, and ill go over each one:


ok so the two below hook up directly to the car (thats a given)

and i believe they somehow splice into these wires (see below)


here a pic of the three togther:


do i just match up the colors, because if i do many of the wires are not used and are left out...

 

the next set of wires...


and



do i actually use these if i have factory speakers and no sub? or are they not necessary?

 

ok heres the rear view camera, as you can see it came with 2 wires. At the end of the camera is a yellow and red input/output sort of thing. And then there is a second wire that i have no clue what to do with....

 

this is the steering wheel adaptor harness to allow me to continue to use my steering wheel functions....

now how the hell does this work?

 

this is the last set of wires that i dont know what they do....they are labled "relay1" and "relay 2"