Disregard my previous....for future ref. for anyone else....

2004 Infiniti G35 Coupe Car Alarm Wiring Guide

Battery Constant 12v+ Positive Wire (+): White/Blue
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Red/White (+) Or White/Red (When installing a remote starter, you must use both starter #1 and starter #2 wires. Both wires must be connected to the starter/cranking output wire from the remote starter or the vehicle will not remote start when the engine is cold.)
Starter Positive Wire Location: Ignition Switch Harness

Secondary Starter Positive Wire (+): White/Green (When installing a remote starter, you must use both starter #1 and starter #2 wires. Both wires must be connected to the starter/cranking output wire from the remote starter or the vehicle will not remote start when the engine is cold.)
Secondary Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Black/Red
Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): White/Black
Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Positive Wire (+): Red/Blue
Parking Light Positive Wire Location: In Drivers Kick Panel, Harness Heading To Rear Of Vehicle

Power Door Lock Negative Wire (-): Yellow (Test these wires while turning the key in the driver door key cylinder.)
Power Door Lock Negative Wire Location: At Drivers Door Module In Drivers Door

Power Door Unlock Negative Wire (-): Light Blue (Requires Double Pulse). Test these wires while turning the key in the driver door key cylinder.
Power Door Unlock Negative Wire Location: At Drivers Door Module In Drivers Door

Door Trigger Negative Wire (-): Yellow And Pink (Use Both). The drivers door is a yellow (-) pin 14, the passenger door is a pink (-) pin 10. When connecting to an alarm system, use both door trigger wires and diode isolate.
Door Trigger Negative Wire Location: At BCM, White 12 Pin Plug, See Note *4

Domelight Supervision Wire: Turns On With Unlock
Domelight Supervision Wire Location: N/A

Trunk Release Negative Wire (-): Pink
Trunk Release Negative Wire Location: At BCM (Brown Plug, Pin 76). The BCM (body control module) is located in the drivers kick panel, the BCM has 4 white plugs and 1 brown plug.

Horn Negative Negative Wire (-): Green/Black
Horn Negative Negative Wire Location: At Steering Column Harness

Tachometer Wire Negative Wire (-): Any Wire Not Black Or White/Blue
Tachometer Wire Negative Wire Location: At Any Ignition Coil

Brake Light Positive Wire (+): Pink/Blue
Brake Light Positive Wire Location: At Switch Above Brake Pedal

Factory Alarm Disarm Wire (-): Disarms With Unlock, Single Pulse Disarms
Factory Alarm Disarm Wire Location: N/A

Factory Anti-Theft Wire (-): Transponder Anti-Theft System. Requires Bypass Module And Extra Ignition Key.
Factory Anti-Theft Wire Location: Transponder At Ignition Switch Tumbler

Immobilizer Bypass Module: Required: Yes
Type: Transponder Part #: 556U or 555U

 

on the same topic, can anyone tell me the wires needed to instal a "window up/down" control?

 

awesome, thanks

 

know this is old,but if the OP ever sees this,THANK YOU SOO MUCH MY DUDE,HELPED AND SAVED ME HUNDREDS IN DOING MYSELF WITHOUT NEEDING TO GET RIPPED OFF BY A SHOP.MY MAN THANKS