Help: G35c Back is higher when Lowered on 350z OEM revised Springs
Joined: Oct 2006
Posts: 6,233
Likes: 168
From: SoCal & Florida
Help: G35c Back is higher when Lowered on 350z OEM revised Springs
I have an 06 G35 coupe 6mt and wanted to lower my car only
a little bit. Well Installed the fronts and they turned out wonderful.
Dropping more than .5 inch and you can tell there was a difference.
But the back of my car seems to have risen slightly. Anyone else
experience this. AND Im having problems with the front left spring.
There seems to be this clicking noise when I run over uneven pavement.
Can someone help me out please with what might be wrong?
a little bit. Well Installed the fronts and they turned out wonderful.
Dropping more than .5 inch and you can tell there was a difference.
But the back of my car seems to have risen slightly. Anyone else
experience this. AND Im having problems with the front left spring.
There seems to be this clicking noise when I run over uneven pavement.
Can someone help me out please with what might be wrong?
Did you compare the spring heights of the two before you installed? Since you have a 6mt, you have the STS with the stiffer 427 springs already, so the 350z revised springs have the same springrate. I would check and see how much difference there is between the springheights, I suspect they are almost exactly the same hence the lack of drop in the rear. If you are only looking for .5" drop in the rear, I suggest you trim the rear rubber springmounts .5" which will net you the drop you are after
Thread
Thread Starter
Forum
Replies
Last Post
netcbc
Steering & Suspension CDN
0
Jul 24, 2015 11:25 AM




