Go with the stance coilovers

 

street racing is very bad.....but you got some nice kills though

nice vids man

 

bc racing coilovers...what size spacers do you guys suggest goin with??

 

^ If your tires aren't OEM sized (225/40/19 & 245/40/19), then I recommend going with 20mm front and 25mm rear spacers. Make sure to get the hubcentric rings.

I'm dropped sort of low (not as low as you) with stock sized tires, and the fronts rub when I turn the wheel enough when going into a driveway.

 

Kevin,

Wait until you get an exhaust. You will despise driveways even more

 

Woah, it sorta looks like you need a camber kit, no? At least in the rear.

Nice drop!

 

Hahah, I scrape my exhaust going out of my apartment driveway almost everytime, unless I use wood blocks. Believe me, both my injured y-pipe & I agree with you entirely.

 

Thanks, so I can pull off 20mm spacers in the front and 25mm spacers in the rear without rubbing while I turn and roll fenders especially wid my car that low??

 

^ What size are your tires?

Like I said, my fronts rub when I'm turning into a driveway, but they don't rub when they're on flat ground. My rear used to rub a tab near where the fender and rear bumper meet, but not anymore since it's basically been worn down.

 

i think my tires are 235/35 in front 245/35 in the rear i kno its not the stock spec size

 

Here's a few old pics of my ride that I found...still had more room to lower the coilovers but I was scraping enough as it was....had to replace my y pipe and cats, plus some hangers got messed up pushing my exhaust back over an inch







Here's one with the Karookie bumper on...

 

^ Rimtuck!

 

Lol, yup. I miss it too. If I did that now, wow, my bumper would literally be split into pieces

 

WOW the bumper looks like its literaly touchin the ground....so f***en low hahah

 

just installed some stance gr pro's