Killed my Fender, how much do you think it'll be?
#1
Killed my Fender, how much do you think it'll be?
Darn, Velocity was closed on saturday, this saturday, while in a hurry in pacific, I totally scratched my back rear fender,
how much you think this will run me at either Dat's place, Velocity, Car Tech or Philada...... or other any other recommneded places?
how much you think this will run me at either Dat's place, Velocity, Car Tech or Philada...... or other any other recommneded places?
#5
#6
Join Date: Nov 2004
Location: Trolling a forum near u.... (T.O.)
Posts: 2,966
Likes: 0
Received 1 Like
on
1 Post
Originally Posted by God|ZIlla168
pefect timing take it to my place they will charge for that and install the lip
300 bucks
300 bucks
#7
Trending Topics
#8
Originally Posted by giddyup69
damn.. where is 'my place' ... looks like the whole quarter panel will have to be repainted. i know a pretty good guy too... but it still cost me 300$ cash just to do the front bumper, i would have thought this would have been well above 500$.
#9
#11
Hey guys just an update, that pic is actually after scratch X, bad eh!!
Anyhow Godzilla's place is actually a good place, the $300 deal was a one off for a different type of car, they actually quote about the same as CarTech, I heard a lot of good things about Car Tech and my friend actually knows them.
I went with Car Tech , cause Godz's place couldn't take my car until next week.
Without me asking, they noticed the OEM 3M guard type on the side and are going to replace that as well.
So things look good so far, will see what happens.
Anyhow Godzilla's place is actually a good place, the $300 deal was a one off for a different type of car, they actually quote about the same as CarTech, I heard a lot of good things about Car Tech and my friend actually knows them.
I went with Car Tech , cause Godz's place couldn't take my car until next week.
Without me asking, they noticed the OEM 3M guard type on the side and are going to replace that as well.
So things look good so far, will see what happens.
#13
Hey --
I just did the same damn thing
What did you end up doing and how much did it cost? I actually had the bevel that sticks out around the tire get pushed in right where the 3M guard is so I dont know if I need a new qtr panel or if they can pop it out. Such a dumb mistake. Thought I had the concrete post cleared.. damn tight underground lots!
Let me know how yours went -- I need suguestions!
I just did the same damn thing
What did you end up doing and how much did it cost? I actually had the bevel that sticks out around the tire get pushed in right where the 3M guard is so I dont know if I need a new qtr panel or if they can pop it out. Such a dumb mistake. Thought I had the concrete post cleared.. damn tight underground lots!
Let me know how yours went -- I need suguestions!
Last edited by Mik3LL; 08-16-2007 at 11:33 AM.
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
12-18-2018 05:43 PM