[QUOTE=Stems;5284942]I'll put your deerfoot outlet mall meet point in the main post. I'm guessing noon right?

noon is great.

 

I was struggling to find something on the main line that was good and open that would allow us to cruise up together easily... but yes- DF Outlet mall sounds good! As for the "as usual," I haven't been there yet... is it any part of the parking lot?

Swivel, when you arrive just lift your hood so that shiny plenum can be our guide!


On another note... and maybe waaaaaay off topic but it's bugging me: Should I bring a jack and some stands? Maybe if someone has access to a roller / heat gun we could have a fender rolling party?

 

i dont have enough offset for this!!

 

Fender rolling might be a little too time consuming for a parking lot meet.

 

Looks ghey with the normal wheels on so why would the stockers be any different?

 

Deerfoot mall sounds good though, i can run over to walmart and get some snacks before we head out

 

Ahhh crap, looks like I'm the only sedan this time. Usually we dominate, WTF??

 

I won't be there and neither will my plenum.
Not to mention the need for electricity to run the heat gun...
We know you'll rep us proudly, Kev!

 

 

Shows how much I know... figured with a little elbow grease and an impact wrench it should be a snap.

So... want to install my valve body upgrade instead?


hahah

 

Fender roller?! What's that.



Hammer time.

 

LOL Yeah, it was approximately when I saw Swivel "No Show" Hips wince when I suggested I use a hammer on my fenders that I decided I didn't have the jam to try that option out on my poor little car.

 

Yea, deerfoot mall on the north side of the parking lot near where the exit off of deerfoot goes. Then you can spot the crew. I'm sure I'll be there first so just look for the IP.

 

Someone bring a hammer and we can make Eno's bumper fit properly

 

Hey Adam, still got any of those fancy cabin filters kickin' around? I missed the meet where you hooked everyone up.