FS: Socal: AMS Dual Core 2" Aluminum Racing Radiator
#1
Socal: AMS Dual Core 2" Aluminum Racing Radiator
AMS dual core aluminum racing radiator. Size is about 29 1/2 x 18 1/2 x 2. Good condition. But there is a very small leak somewhere near the fins. I can't really see it or find where it is leaking at. I had this installed on my 03 G35 Sedan 5AT with dual electrical fans and thermostat control start relay for the e-fan and aftermarket tranny oil cooler. I am also selling that too if any of you interested in converting your mechincal clutch fan to electric fan. Going back to stock, no longer need it. Prefer local sales. Socal in Alhambra area. $40
Here are the spec from AMS website:
Huge racing core - 50 mm (2”) single pass vs. 15.8 mm (5/8”) stock!
• Holds an extra 2 litres of coolant vs. stock!
• All-aluminum construction to ISO 9001 manufacturing standards
• One Year Limited Manufacturer Warranty!
• Over-sized, fully polished end-tanks
• 45 fins per square inch, allowing for less restriction across the core
• Thick-walled billet welded neck
• Extra thick flared inlet and outlet pipes, allowing for aggressive tightening of clamps
• OEM mounting points for fan assembly and A/C condensor (some additional trimming required)
• Aluminum drain plug
• AMS laser-etched logo
• AMS colour painted logo on both sides
• 1.3 high pressure cap included
Here are the spec from AMS website:
Huge racing core - 50 mm (2”) single pass vs. 15.8 mm (5/8”) stock!
• Holds an extra 2 litres of coolant vs. stock!
• All-aluminum construction to ISO 9001 manufacturing standards
• One Year Limited Manufacturer Warranty!
• Over-sized, fully polished end-tanks
• 45 fins per square inch, allowing for less restriction across the core
• Thick-walled billet welded neck
• Extra thick flared inlet and outlet pipes, allowing for aggressive tightening of clamps
• OEM mounting points for fan assembly and A/C condensor (some additional trimming required)
• Aluminum drain plug
• AMS laser-etched logo
• AMS colour painted logo on both sides
• 1.3 high pressure cap included
Last edited by SupG35; 01-17-2013 at 08:29 PM.
#4
Sorry, dont have any pics when its was on my car. But everything bolt up with no problem at all. Just a little plastic trimming on the front main frame where the a/c condensor sit to accomodate the thicker radiator. Say so on the AMS website. What do you mean by "able to retail oem intake snorkel"??? If u mean the ram air duct, i think so.
#6
i forgot but i'm pretty sure it will still work. cause i remember i had to put back the stock oem intake and the snorkel with the AMS radiator to get smog. so it should fit fine. and yes, the cap is on the left side.
The following users liked this post:
G'dUpFrmFeetUp (05-13-2012)
#7
Trending Topics
#9
I found where the leak is coming. It is on the top end cap of the radiator. I would take a picture of it but you could barely see it. There is a hole the size of a small needle on one of the fin and also a hair line crack on another fin. You can see the hole and try to have it weld or maybe epoxy. But it's not leaking like super crazy, just very little. So I'll let it go for $50 and sold as is. Or $100 for the radiator, 2 fans and the thermostat control fan relay.
#10
#11