burn out mod
Thread Starter
|
Registered User
Joined: Dec 2009
Posts: 14
Likes: 0
From: halifax,Nova Scotia
burn out mod
http://www.nissanforums.com/titan-ar...rnout-mod.html
wonder if theres anything like this for the g?
wonder if theres anything like this for the g?
Thread Starter
|
Registered User
Joined: Dec 2009
Posts: 14
Likes: 0
From: halifax,Nova Scotia
ok, here we go lol
diconnect and remove battery.
remove battery tray (4 bolts)
pull out bottom ECM plug
cut open harness and find red wire with white stripe.
mount any type on on/off switch in cab (where ever you want the switch)
run wires from switch through firewall and into engine bay(near fuse box)
cut the red/wht wire, and connect the ECM end of the red/wht wire to the acc side of the switch and the other end of the red/wht wire to the supply side of the switch, tape em up and re-assemble verything in the revese order from above, your done.
for normal driving operation --- switch in "on" position
for burnout mode --- switch in "off" position
now for the reasoning behind this mod.
when doing a brakestand/powerbrake burnout, the ECM see's that ur on the brake pedal and only allows the TB to open about 10%, making a burnout very hard and weak, this mod will basically blind your ECM so it wont see that ur on the brake, and will not limit the TB.
diconnect and remove battery.
remove battery tray (4 bolts)
pull out bottom ECM plug
cut open harness and find red wire with white stripe.
mount any type on on/off switch in cab (where ever you want the switch)
run wires from switch through firewall and into engine bay(near fuse box)
cut the red/wht wire, and connect the ECM end of the red/wht wire to the acc side of the switch and the other end of the red/wht wire to the supply side of the switch, tape em up and re-assemble verything in the revese order from above, your done.
for normal driving operation --- switch in "on" position
for burnout mode --- switch in "off" position
now for the reasoning behind this mod.
when doing a brakestand/powerbrake burnout, the ECM see's that ur on the brake pedal and only allows the TB to open about 10%, making a burnout very hard and weak, this mod will basically blind your ECM so it wont see that ur on the brake, and will not limit the TB.
Registered User
Joined: Aug 2007
Posts: 72
Likes: 1
Trending Topics
Thread Starter
|
Registered User
Joined: Dec 2009
Posts: 14
Likes: 0
From: halifax,Nova Scotia
hey no need to be *******s i just thought id post it to see if anyone heard of it. From what i read the g35's have a 0-60 restriction and was curious to see if this was a way to get rid of it without using a handheld
Registered User
iTrader: (9)
Joined: Dec 2004
Posts: 658
Likes: 0
From: Indianapolis or Bloomington Indiana
I did sort of a write up on this in 2008. Its for brake boosting but it does the same thing. FYI you would need to do this even if you had a 6mt in order for it to do a burnout.
http://my350z.com/forum/forced-induc...-ftw-11-a.html
http://my350z.com/forum/forced-induc...-ftw-11-a.html