Help Wideband Commander install G35c
Thread Starter
|
Registered User
Joined: Jul 2003
Posts: 137
Likes: 0
Help Wideband Commander install G35c
I am installing a new Wideband commander unit to log/monitor A/F. I need to verify the following connections at the ECU harness. Anyone with knowledge please let me know if this seems correct. My tech manual says the following:
============================================
** Throttle Position Sensor **
Accelerator pedal fully released More than 0.36V
Accelerator pedal fully depressed Less than 4.75V
Terminal number 50 White wire
-OR-
Accelerator pedal fully released Less than 4.75V
Accelerator pedal fully depressed More than 0.36V
Terminal number: 69 R/L color
* Not sure of the correct connection to use
============================================
** RPM Sensor **
Pin Color
60 PU Ignition signal No. 5
61 WL Ignition signal No. 3
62 RY Ignition signal No. 1
* Not sure of the correct connection to use
============================================
Too many mods to list… Complete Web Site
============================================
** Throttle Position Sensor **
Accelerator pedal fully released More than 0.36V
Accelerator pedal fully depressed Less than 4.75V
Terminal number 50 White wire
-OR-
Accelerator pedal fully released Less than 4.75V
Accelerator pedal fully depressed More than 0.36V
Terminal number: 69 R/L color
* Not sure of the correct connection to use
============================================
** RPM Sensor **
Pin Color
60 PU Ignition signal No. 5
61 WL Ignition signal No. 3
62 RY Ignition signal No. 1
* Not sure of the correct connection to use
============================================
Too many mods to list… Complete Web Site
Thread
Thread Starter
Forum
Replies
Last Post
