oil cooler setups?
#17
Wings Nation
iTrader: (59)
^ that's a sick setup!
OP, i found Cheston's thread on my350z.com to be very helpful when putting together my oil cooler:
http://www.my350z.com/forum/forced-i...56k-pwn3d.html
OP, i found Cheston's thread on my350z.com to be very helpful when putting together my oil cooler:
http://www.my350z.com/forum/forced-i...56k-pwn3d.html
#20
#21
Registered User
iTrader: (25)
^ that's a sick setup!
OP, i found Cheston's thread on my350z.com to be very helpful when putting together my oil cooler:
http://www.my350z.com/forum/forced-i...56k-pwn3d.html
OP, i found Cheston's thread on my350z.com to be very helpful when putting together my oil cooler:
http://www.my350z.com/forum/forced-i...56k-pwn3d.html
#22
Wings Nation
iTrader: (59)
i don't recall taking any pix, but when i get home tonight i'll check my laptop. I pretty much followed Cheston's layout, but Dave from Rare JDM made me some custom brackets that mount to the bottom of the crash bar. i think mounting to the radiator support should be secure enough, but i wanted to position my coolers further forward but still above my intercooler piping.
i do have a parts list i can send you though.
i do have a parts list i can send you though.
#25
#29
Wings Nation
iTrader: (59)
My parts list is below:
(1) Earl's #41610 16 row cooler
(1) 6' of -10AN Earl's Pro-lite hose (you can go with stainless or another brand if you want, but this stuff flexes better. also, i think i only ended up using 5').
(3) -10AN 90 degree swivel fitting & hose end (1 will go on the cooler, the other two will connect to the sandwich plate)
(1) -10AN 150 degree swivel fitting & hose end
(1) Mocal thermostatic sammich plate (thread = 20mm x 1.5)
(2) Mocal 1/2" BSP x -10 fitting (you need these because the mocal sandwich plate has BSP threading).
As for the bracket, you can piece together misc straps/plates/etc from Home Depot.
Cheston's parts list:
http://my350z.com/forum/1826219-post63.html
Note, he went with Earl's fittings for the sandwich plate that did not require adapter fittings.
(1) Earl's #41610 16 row cooler
(1) 6' of -10AN Earl's Pro-lite hose (you can go with stainless or another brand if you want, but this stuff flexes better. also, i think i only ended up using 5').
(3) -10AN 90 degree swivel fitting & hose end (1 will go on the cooler, the other two will connect to the sandwich plate)
(1) -10AN 150 degree swivel fitting & hose end
(1) Mocal thermostatic sammich plate (thread = 20mm x 1.5)
(2) Mocal 1/2" BSP x -10 fitting (you need these because the mocal sandwich plate has BSP threading).
As for the bracket, you can piece together misc straps/plates/etc from Home Depot.
Cheston's parts list:
http://my350z.com/forum/1826219-post63.html
Note, he went with Earl's fittings for the sandwich plate that did not require adapter fittings.