convert heads to revup
I've seen a few mention that DE heads can be drilled to accept the exhaust timing solenoids.
Has anyone done this? I searched around quite a bit and was unable to find anything. I know where the bosses are cast and have seen them, but I am unsure about dimensions without going and looking at the old de heads off my 02 maxima. If anyone has done this can someone please point me in the correct direction? I am looking to build a long block for my revup car and it seems that non revup engines are much easier to procure. |
almost 50 views and not one person? Dang, that's depressing.
|
it prob cause no one has done it. prob easier to just buy a rev up motor. saves you the hassle and headache of problems you might run into.
|
bump it up. Someone has to have some info here?
|
All times are GMT -4. The time now is 04:31 AM. |
© 2024 MH Sub I, LLC dba Internet Brands