I've seen a few mention that DE heads can be drilled to accept the exhaust timing solenoids.

Has anyone done this? I searched around quite a bit and was unable to find anything. I know where the bosses are cast and have seen them, but I am unsure about dimensions without going and looking at the old de heads off my 02 maxima.

If anyone has done this can someone please point me in the correct direction?

I am looking to build a long block for my revup car and it seems that non revup engines are much easier to procure.

 

almost 50 views and not one person? Dang, that's depressing.

 

it prob cause no one has done it. prob easier to just buy a rev up motor. saves you the hassle and headache of problems you might run into.

 

bump it up. Someone has to have some info here?