'07 Camshaft Position Sensor Location
#1
#5
Okay, so I was right. That DIY isn't for '07+. The good news is that '07+ is way easier. Took about 5 minutes.
In case anyone else needs it, there are four sensors (two on each side) and they're all the same. Bank 1 is on the passenger side on the side of the back.
The plug is gray and it pulls right off without tools. As usual, 10mm bolt and the sensor pulls right out. The sensor is round (instead of rectangular) and about half the size of the old ones. You only need to pull the engine cover off to access all four of them on both sides. Cost about $60 each at Advance.
I reset the SES light with a cheap scan tool and the car drives like new. Actually sounds different, too. Quick response is back and it doesn't feel heavy like it did before.
In case anyone else needs it, there are four sensors (two on each side) and they're all the same. Bank 1 is on the passenger side on the side of the back.
The plug is gray and it pulls right off without tools. As usual, 10mm bolt and the sensor pulls right out. The sensor is round (instead of rectangular) and about half the size of the old ones. You only need to pull the engine cover off to access all four of them on both sides. Cost about $60 each at Advance.
I reset the SES light with a cheap scan tool and the car drives like new. Actually sounds different, too. Quick response is back and it doesn't feel heavy like it did before.
#6
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,301
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods