This mani was included when i bought a used powerlab kit for my 04 350z. The orginal owner had it made to fit his g35. the shop that did my install did a test fit, and it doesnt have to clearence for the hood to close.

included also is one of the cold pipes that youll need to make this work. it has the flanges welded for the maf and hks bov.

youll need to have another pipe fabbed to make it down to the intercooler.

any questions at all, please ask!

I'm asking $1200 Shipped/paypal'd

Name: Andrew
Phone: (four one two) 719 7676
Location: Pittburgh, PA

 

Damn that's sweet.. Glws

 

I remember seeing a thread in my350 about this intake, pretty sick. GLWS!

 

thank you! its definitely a nice piece. my pictures dont do it justice!

 

Nice. Where in the Burgh is it?

 

Im in West Mifflin!

 

heres some more pics...bump!

 

Bump!

Open to offers...

 

Once my bonus clears I might be giving you a shout hopefully within the next few weeks ill be good. So im confused this is a 350z part from Powerlab but it wont fit on your Z or G?

So it should be fine on my G coupe if so......... ill be letting you know something soon. I actually wanted to buy one.

 

The orginial owner had a g35 coupe (revup).

this manifold is a one-off piece (supposedly made by weapon r), it was mated to a stock powerlab kit.

Im not sure if its the engine height or angle on a Z, but my hood wouldnt close with the manifold in place.

The pipe the im including will get you from the the throttle-body >close to your intercooler. It has the flanges for the maf and hks bov already welded, which definitely cuts down the the cost.

 

My car is non rev up it should still bolt up right. ourr right it looks similar to powerlabs single manifold but the plenum is definitely different

 

Reminds me of the intake manifolds found on the early to mid 90's SHO.

 

Still Available!

 

Bump..

 

That's HOT! GLWS.