I got my bluebatmobile tail light and valance overlays yesterday, and I dont really know how to put them on correctly. So does anyone who has had some experience with them want to help me? Or do you know if any local tint shops might do it for me.

thanks alot

 

Well I was in the same boat and decide I would just try it. If I messed them up I was out a few bucks... I did my head lights. Took about an hour and half but I was very carfeul as I did not know how they would go on.

Advice,
1. Be Patient!

2. The Hair dryer works well for getting the film to mold around the bends.
3. Use lots of soap and water and keep moving it around til you get them where you like.

4. Be patient... took me a while on the first one as I had to take it off a few tims and start over. Lucky I had not heated the film and it was not streched out.

5. I used a small cali-blade to get the water and air bubbles out. Then used a credit card wraped in a microfiber towel.

It was not a bad install. Just keep working with it. If you want some help I would be happy to help you, however I am no expert and have only done one set.

 

talk to Ian

 

Someone say overlays?

 

Indeed, am I to take it that you are the local overlay master?

 

I think he works for Dorritos

 

That's the understatement of the century!