im right in town n country ... next to G35_FTMFW

 

ahh ok. not too far from me. sucks i dont have my car right now.

 

i see ... hows the TT comming along ... i tried to take my car to b2 auto today but Adrian is really slammed today .. i need to get my fenders cut before i put on my springs ... i was really hoping for today cause i am off work ...

 

S&R is putting in my built motor this week. Yea adrian is always slammed

 

im going to try and squeeze in this week i really want to drop my car :-)

 

lol whats your suspension?

 

i have 350z tein s-techs and a +35 with 265 in the rear and i need to have them cut or rolled but im going to get them cut ...

 

Why do you need to cut them? im on s techs and im run 285s in the rear and i didnt need to do that.

 

really ?? ... some of the guys are telling me i need to get them rolled or cut .... o and i have a sedan :-) thats prob why

 

I'm on the z stechs with 275s in the rear and I'm fine, but if I get spacers then I will probably need to do something about it.

Let's get some Tampa meets set up! Check out this thread for the z peeps Tuesday night meet info.

 

i have a sedan so i cant run the offsets you guys have ... with what i have now everyone in the forums I'm in are saying i should roll them and very few say i don't need to . but with all that i think I'm going to be safe then sorry and get them done that way when i put spacers on and stuff to go aggressive ill all ready have everything trimmed :-)


and I'm down for a good meet around here .. i would love to come to the orlando ones but since it being during the week i can't make it due to crazy work hours ..

when is this little meet going to be ??

 

i think it would make a difference sedan and coupe but yea thats weird. But yea it looks to me that we have about 5 ppl that want this meet to start. V i think i will take your advice and start with z peeps.

 

I hope to make the meet Wednesday in Orlando.

 

just let me know when we decide to start a meet in tampa ..

 

dont forget z springs on a sedan is +1'' and coupe springs are +.5'' you have the z stechs as well as i do but im going to drop another .5 dont forget :-) thats prob why i need to have them rolled/cut