December 2010 discussion thread !!!
Registered User
iTrader: (3)
Joined: May 2007
Posts: 4,383
Likes: 27
From: pinellas county FLA, queens N.Y.
Registered User
iTrader: (7)
Woohoo! Ipod install starts today!
So just to summarize the tips i should stick to:
-disconnect battery after
-hands must be wet while working on wires
-helpful if standing barefoot in a salt puddle
I'll tell you guys later how it goes! woohoo!
So just to summarize the tips i should stick to:
-disconnect battery after
-hands must be wet while working on wires
-helpful if standing barefoot in a salt puddle
I'll tell you guys later how it goes! woohoo!
Went up on the frame machine and frame was pushed back 2cm.
Got it straight and now have to bolt the crossmember back up and them back to the frame machine and then alignment.
Funny thing is, they had to raise the rack up level to the trailer and push my car onto it bc it's too low
Got it straight and now have to bolt the crossmember back up and them back to the frame machine and then alignment.
Funny thing is, they had to raise the rack up level to the trailer and push my car onto it bc it's too low
i want my car back
for those that don't know the story. one day i decided to take my car to a place to get HAND washed and waxed but someone missed the memo about the HAND part and tried to drive it through their wash. Ended up bending the cross member.
but it turns out that 2 bolts that bolt the cross member to the frame were so bent that when they were taken out, it stripped out the bolt holes which now have to be cut off and new ones welded on.
for those that don't know the story. one day i decided to take my car to a place to get HAND washed and waxed but someone missed the memo about the HAND part and tried to drive it through their wash. Ended up bending the cross member.
but it turns out that 2 bolts that bolt the cross member to the frame were so bent that when they were taken out, it stripped out the bolt holes which now have to be cut off and new ones welded on.
