you will be able to take advantage of the core swap.

 

Oh.... good looking out. I'll hold off until the sale. I was following that thread too, but I missed his comments on the sale. A group install sounds good, I'm always down for getting some help from those with more experience.

 

chuck and I installed the iso-thermal gasket, throttle body heater cut off valve and the plenum spacer on both of my G's. It's not difficult and doesn't take too long. Just pay attention to the bolt loosening/tightening sequence outlined in the instructions.

 

Yeah I read those instructions and it seems pretty stright forward. I always do my lugs in a pattern so I am certain I wont forget this important step.

I am going to go to sears tomorrow and look at in lb torque wrench if it too much prolly just rent one frm the local AZ

 

Many times you can borrow one from PepBoys or other local auto shop.
Just give'em a deposite and your good to go. Use it the whole day on all the cars and it won't cost you a dime.

 

Thanks... Man you are all over the place

Ok guys so who all is in on the the group install?

I'd like to see what you guys think about the process. Should we pair up and tear down and install the mrev or have a tear down team and an install team...