Xenon HIDs
#18
Guest
Posts: n/a
#19
Re: Xenon HIDs
Actually, you don't even need to buy new bulbs. Just take out your existing D2R bulbs and scrape the black stripe off, and you basically have a D2S bulb. There's a faq on how to do this on the HID FAQ (the faq.auto.tripod or whatever site).
And you won't be able to buy a "better" xenon bulb. Our bulbs are Philips, just D2R though. A Philips D2S 4100K bulb is the brightest HID bulb out there.
And you won't be able to buy a "better" xenon bulb. Our bulbs are Philips, just D2R though. A Philips D2S 4100K bulb is the brightest HID bulb out there.
#22
#23
Re: Xenon HIDs
I have D2S bulb on my coupe. The bulb is exactly same except the D2R has strip on the bulb. Its barely noticeble in terms of light out put between those two in the reflector housing. your best solution is aim the HID little bit higher. It's very easy and then u will really see the difference. I personally think that the stock HID is aiming too low.
Nuttin chillin in da holydae in
Nuttin chillin in da holydae in
#24
Guest
Posts: n/a
Re: Xenon HIDs
Yeah, I did aim them a little higher. Any higher than what I have now, and it will just be blinding. Sometimes people flash me while driving at night already. =(
Seriously, though...since the lights suck and there's nothing I can do, I'm kinda in the mood to get a pair of 8000K D2S bulbs...at least they'll look insanely blue and have mad glare.
Seriously, though...since the lights suck and there's nothing I can do, I'm kinda in the mood to get a pair of 8000K D2S bulbs...at least they'll look insanely blue and have mad glare.
#25
Re: Xenon HIDs
<blockquote><font class="small">In reply to:</font><hr>
your best solution is aim the HID little bit higher. It's very easy and then u will really see the difference. I personally think that the stock HID is aiming too low.
<hr></blockquote>
I do too. On dark roads the low beams seem to cut off too low, leaving an unlit dead zone too close ahead. Going repeately back and forth to hi-beams is a hassle. I wonder (this is directed to MrE as well) how much higher the lows should be adjusted. I'm due for service soon. Maybe I should ask them to adjust them.
your best solution is aim the HID little bit higher. It's very easy and then u will really see the difference. I personally think that the stock HID is aiming too low.
<hr></blockquote>
I do too. On dark roads the low beams seem to cut off too low, leaving an unlit dead zone too close ahead. Going repeately back and forth to hi-beams is a hassle. I wonder (this is directed to MrE as well) how much higher the lows should be adjusted. I'm due for service soon. Maybe I should ask them to adjust them.
#26
Re: Xenon HIDs
Adjust the lights a liittle higher, it is all you can really do outside of changing over to refractors.
Mr. E, don't put out "mad glare" unless you are itching to get into a head-on wreck. People who have consumed alcohol have a tendancy to steer towards bright lights, so unless you never drive on a two-way two lane road I'd advise against blinding the oncomming drivers.
JD
2003.5 Coupe, Blk/Blk
Mr. E, don't put out "mad glare" unless you are itching to get into a head-on wreck. People who have consumed alcohol have a tendancy to steer towards bright lights, so unless you never drive on a two-way two lane road I'd advise against blinding the oncomming drivers.
JD
2003.5 Coupe, Blk/Blk
#27
Re: Xenon HIDs
If you are really that disappointed in your lights - adjust them higher and change out the fogs. You can change out the fogs to a better non-HID bulb like the Silverstars or Raybrigs. The next level would be adding on something like the CATZ Zeta to the fog - it will ramp up the brightness even more. I was fine after doing the above 3 steps. Or - you could purchase one of the aftermarket HID kits like McCulloch and change out the fog's to a HID. Then you should have more than enough brightness.
Thread
Thread Starter
Forum
Replies
Last Post
FS[NorEast]: FOR SALE: 2007 G35X (82K miles, Asking $12,000)
heynow
2nd Gen (V36) Sedan
3
10-28-2015 05:09 PM