First of all, I Just wanted to thank everyone in the forum for all there input. My car couldn't have been done without this place.
Has anyone put revised 350z springs in the front and 350z htechs in the rear? I have the revised 350z springs for my 05 coupe and I just dont like the fact that the rears didn't lower at all or if any. I remember reading a long time ago that someone asked the same question but I can't seem to find the post. It seems like my car is .7/.8 in the front and .25 in the rear.
Has anyone put revised 350z springs in the front and 350z htechs in the rear? I have the revised 350z springs for my 05 coupe and I just dont like the fact that the rears didn't lower at all or if any. I remember reading a long time ago that someone asked the same question but I can't seem to find the post. It seems like my car is .7/.8 in the front and .25 in the rear.
Registered User
isnt it suppose to be the other way around? since the rear is already a bit lower than the front stock.......so you wanna kinda balance it out....
youre not going to be happy with the drop in the rear with z h techs
Registered User
If you are satisfied with the front drop, but not the rears, then cut the upper springmount to even up the drop. If you cut 1/2" off then it will be even and you get to keep the stiffer revised springs. Or I'll trade you my rear z-htechs for your 350z revised rear springs
nevermind guys...i've seen the other posts that redlude and ahero were talkin about the springs....will cutting the uppermounts cause a harsher ride?
Registered User
in theory, yes, but i didn't notice any difference. Be ready to purchase a camber kit for the rear however, buts thats expected for any significant drop